VoltCheck24 Engineering Calculator

Control Panel Cooling and Enclosure Heat Load Calculator

Calculate control cabinet heat load and select filter fans, air conditioners, or cooling capacity for industrial enclosures.

Open Interactive Calculator Open HVAC Blower Calculator

How to use this calculator

  1. Collect the values below from the equipment nameplate, data sheet, or field measurement.
  2. Enter values using one consistent unit system and use worst-case operating conditions.
  3. Review the result, margin, and engineering note before selecting hardware.
  4. Cross-check the result with the related calculator and save the review for your project record.

Input checklist

Example field question

Use this calculator when a design review or site issue requires a quick engineering check before a detailed manufacturer selection.

Common mistakes to avoid

Do not mix nominal values with measured worst-case values. Keep units consistent and include cable, temperature, duty, and derating assumptions where applicable.

Standards and validation

Review the result against local codes, IEC/NEC/NFPA/ISO practices when applicable, project specifications, and the latest manufacturer data sheet.

Recommended workflow

Start with the primary calculation, then use the related tool to check the next design dependency. Save or print the result only after the assumptions and worst-case conditions are confirmed.

Start with the primary inputsCheck the related dependency

Formula and Inputs

Required cooling capacity is estimated from internal heat dissipation, ambient temperature, target enclosure temperature, and enclosure conditions.

Industrial Use Cases

Use this calculator for PLC panels, inverter cabinets, servo cabinets, battery equipment, and sealed industrial control boxes.

Engineering Note

Include losses from power supplies, drives, contactors, transformers, and external heat transfer. Check dust, oil mist, IP rating, and altitude derating.

FAQ

When should I use a panel air conditioner?

Use an air conditioner when ambient temperature approaches or exceeds the target internal temperature, or when the enclosure must remain sealed.

Should I calculate heat from motor output power?

Use the electrical losses that become heat inside the enclosure, not the full mechanical output power.

Preliminary engineering reference only. Confirm final selections against current standards, project specifications, and manufacturer data.